3.1 Descriptions and Wiring of CNC Interface

 

                                                                                 Figure 3.1 Information of CNC BOX

3.1.1 Basic parameters

Table 3.1 Basic parameters of CNC BOX

Line supply voltage

Single-phase AC 220V

Screen

12 inches color touch screen

PLC

Soft-PLC,ST language programming

Communication

USB, EtherCAT, Network

Sinusoidal vibration frequency

<=55Hz

Storage Temperature

-20-70℃

Working Temperature

5-40℃

Relative humidity

10 ~ 90% RH, No condensation

3.1.2 Interface Overview

                                                            Figure 3.2  CNC BOX Interface Overview

Table 3.2 CNC BOX Interface list

Number

Descriptions

JP1

EtherCAT communication interface

JP2

i-Port network port

JP3

Emergency stop interface

JP4

External 220V AC power supply interface

JP5

Internal power supply module

JP6

Electrical grounding

JP7

Handheld device interface, 32-pin female connector

3.1.3 Wiring example

                                            Figure 3.3 Wiring example of CNC BOX

Wiring example of CNC

                                                                    Figure 3.4 Wiring example of CNC

0 (0)
Article Rating (No Votes)
Rate this article
Attachments
There are no attachments for this article.
Comments
There are no comments for this article. Be the first to post a comment.
Full Name
Email Address
Security Code Security Code
Related Articles RSS Feed
3.3 Definitions and Wring of PLC Board Interface
Viewed 11680 times since Wed, Aug 24, 2016
1.2 Analog spindle & Digital servo-control
Viewed 2766 times since Wed, Aug 24, 2016
1.3 All-digital control
Viewed 2077 times since Wed, Aug 24, 2016
3.4 Interface definitions and wiring of Driver
Viewed 31570 times since Wed, Aug 24, 2016
1.1 All-analog control
Viewed 1923 times since Wed, Aug 24, 2016
2.1 Installation of CNC BOX
Viewed 3278 times since Wed, Aug 24, 2016
1. i5 System Brief description
Viewed 2041 times since Wed, Aug 24, 2016
2.2 Installation of DAC Board
Viewed 1581 times since Wed, Aug 24, 2016
2.3 Installation of PLC Board
Viewed 1656 times since Wed, Aug 24, 2016
2.4 Installation of Driver, Motor and Accessories
Viewed 3737 times since Wed, Aug 24, 2016