2.6 Work plane G17/G18/G19
Article Number: 497 | Rating: Unrated | Last Updated: Thu, Aug 25, 2016 2:44 PM
1. G17: X/Y plane
2. G18: Z/X plane (default G18)
3. G19: Y/Z plane
You mut determine the work plane before workpiece machining. Then tool radius compensation plane and infeed direction of tool length compensation is determined.
Fig.2.7 G17-19work plan definition
There are no attachments for this article.
There are no comments for this article. Be the first to post a comment.
Related Articles
3.4 Tool group TGROUP
Viewed 1950 times since Fri, Aug 26, 2016
2.3 Radius / diameter: DIAMOF/DIAMON
Viewed 3277 times since Thu, Aug 25, 2016
2.4 Coordinate transformation
Viewed 2726 times since Thu, Aug 25, 2016
5.2.5 Reaming1 (boring 1) CYCLE85
Viewed 10653 times since Fri, Aug 26, 2016
4.2 System parameter
Viewed 3696 times since Fri, Aug 26, 2016
3.2 Tool offset number D
Viewed 1995 times since Fri, Aug 26, 2016
1.7 The instructions table
Viewed 2294 times since Thu, Aug 25, 2016
5.2.9 Reaming 2 (boring 5) CYCLE89
Viewed 1965 times since Fri, Aug 26, 2016
Subscribe to Article
Email Article to Friend