2.10 Dwell Time: G04

Between two NC blocks you can interrupt the machining process for a defined period by inserting your own block with G4; e.g. for relief cutting.

Words with H.. are only used for times in this block, and dwell time is given as the word.

Example:

G04 H…                                                    ; Dwell time in seconds

Note:

Nubers after H accurate to two decimal places. G04 instruction requests separate block.

0 (0)
Article Rating (No Votes)
Rate this article
Attachments
There are no attachments for this article.
Comments
There are no comments for this article. Be the first to post a comment.
Full Name
Email Address
Security Code Security Code
Related Articles RSS Feed
5.2.1 Drilling, centering CYCLE81
Viewed 13253 times since Fri, Aug 26, 2016
2.9 Exact stop/continuous-path control mode: G09/G60/G64
Viewed 2960 times since Thu, Aug 25, 2016
1.7 The instructions table
Viewed 1993 times since Thu, Aug 25, 2016
4.1 Arithmetic parameter R
Viewed 1559 times since Fri, Aug 26, 2016
5.2.4 Rigid tapping CYCLE84
Viewed 3057 times since Fri, Aug 26, 2016
5.3.3 Rough turning CYCLE95
Viewed 11250 times since Fri, Aug 26, 2016
5.2.9 Reaming 2 (boring 5) CYCLE89
Viewed 1712 times since Fri, Aug 26, 2016
Preface
Viewed 1715 times since Thu, Aug 25, 2016
3.3 Tool offset table
Viewed 3868 times since Fri, Aug 26, 2016
1.1 Coordinate systems
Viewed 3300 times since Thu, Aug 25, 2016